Interface universelle 4 DI / 2 relais 5A

ORDERING CODE EK-CE2-TP DESCRIPTION KNX bus device functioning as 4-channel input for the connection of potential-free contacts (1 configurable for NTC temperature probe) and 2-channel output with 5A relais switching and control of loads. Mounting in wall box or on 35 mm rail (EN 60715) with the support EK-SMG-35 (to be ordered separately). Power supply via bus. Bus terminal block included in the delivery. To be used in KNX installations for home and building automation. FUNCTIONS / CHARACTERISTICS INPUTS (CONFIGURED FOR FREE-POTENTIAL CONTACTS) • ON / OFF control of single and group utilities • Dimming of lighting fixtures • roller blind operation (rolling shutters, blinds, curtains, etc.) • Signal contact status detection (from safety devices, alarms, etc.) • recall and store scenarios • sending on the values bus (temperature, brightness, etc.) • switching in forced operation (blocking) • pulse and drive counts INPUT 1 (CONFIGURED FOR NTC 10 kΩ at 25 ° C) • Measurement of the ambient air mass temperature with the possibility of sending the value on the bus or using the value for regulation by means of integrated thermostat function OUTPUT FUNCTIONS / CHARACTERISTICS (BINARY OUTPUT) • ON / OFF control of single or group utilities • Configuration as a normally open or normally closed switch • Logic ports and forced operation for each channel • Block function for each channel • Timing: on / off delay, scale light function with signaling of notice • Integration into scenarios • Bus operating time counters can be configured (SHUTTER ACTUATOR) • Full stroke of climb and descent • Partial stroke with stop to 0 to 100% of stroke length • Position setting (change during operation of the preset position) • Adjustment of tilt slats (for venetian blinds) • Insertion into scenarios • Automatic control for direct sunlight protection • Automatic control for protection against atmospheric conditions (rain, wind, frost) CONFIGURATION AND COMMISSIONING A detailed description of the parameters can be found in the application manual of the device. Configuration and commissioning require ETS4 2.0 or later versions. ETS application program: APEKCE2TP##.knxprod (## = release). Available languages: English, French, German, Italian